Anderson Power Pipe® 96-04 GT Mustang & 96-01 COBRA Using Vortech or Paxton SC's (Please specify supercharger model when ordering)
We have seen an 8 rwhp improvement on the AFM dyno with no other changes than the Anderson Power Pipe® using the stock Vortech pullies. With smaller pullies we have seen increases of one to three pounds of boost over the standard Vortech inlet pipe
The AFM POWER PIPE®, with its all mandrel bent construction, is the highest flowing inlet pipe available for centrifugal superchargers. We also put the mass air in the inner fenderwell for a cooler intake charge.
AFM POWER PIPES® were developed because of the need for a supercharger intake pipe that would flow at a higher rate of CFM, with a larger volume of air, brought on by the demand that new Vortech, Procharger and Paxton have when making 10 lb of boost or more.
In the box: S/C to Pipe 90 degree coupler, aluminum pipe, 90 degree bypass fitting, 4x4 inch humped coupler with 3.5 inch insert and clamps
Fits ProM 80mm/92mm, SCT BA2600/3000, Lightning and PMAS 80/90mm mass air meters
*This system was developed to work with the factory Vortech discharge systems both aftercooled and standard, if running a custom front mount intercooler modification may be required.
