Tuner Kits, Upgrades, More HP
For higher-horsepower, custom-tuned installations we recommend a tuner kit, which does not include a fuel pump, fuel injectors or ECU programmer. This requires you or your installer to provide custom calibration and the required fuel components. The V-3 Si-Trim supercharger included with the tuner kit is capable of up to 775HP on modified vehicles. Tuner kits are also available as the Competition Tuner Kit, with the 1,000 HP capable V-7 JT-Trim supercharger for high-performance racing vehicles.
Superior Technology
- Centrifugal superchargers easily make more pressure and flow than a roots type blower and are much more efficient. Read our Roots vs Centrifugal comparison to see the numbers.
- Vortech supercharger systems are a great value. Dollar for dollar, Vortech systems deliver more horsepower than virtually any other method of upgrade. Also, driven normally, gas mileage often increases rather than decreases.
Supercharger Kit Finishes
- Multiple kit finishes available. For that fully integrated look, S550 Mustang systems are available in factory matching black finish. Satin and Polished units are also available.
Included Components and Features
- V-3 Si-Trim compressor with 3.60" drive pulley
- Optional V-7 JT-Trim Head Unit includes 8-Rib pulley system
- Manifold boost pressure: 7.5-8.5 psig @ redline on stock engine
- Air-to-Air Intercooler
Air inlet assembly includes:
- - High-flow roto-molded ducting. Mates to OEM airbox and some aftermarket "CAI" MAF/inlet assemblies
- - OEM replacement K&N panel filter
- - Silicone sleeves and reducers
- - Stainless steel clamps
- - PCV and breather hose provisions
- - Replacement engine coolant pipe and hose assemblies
- - Engine coolant reservoir replacement assembly
- - Dual plate supercharger mounting system includes idlers, drive belt and all hardware. Mount features multiple position idler location for a wide range of belt and pulley fits.
Discharge components include:
- - High flow air/air charge cooler. 24" x 13" x 3.5" cooler core.
- - Mandrel bent 3" and 3.5" aluminum charge tubes for high flow and minimal weight
- - Stainless steel clamps
- - Silicone sleeves
- - 98mm MAF housing configured for "blow-through" use. Integrated air-straightener upstream of the MAF housing.
- - Vortech Maxflow Race Bypass Valve with filter
Installation
- Installation time is rated at 6-9 hours
- INSTALLATION MANUAL
CARB Compliance
- Tuner Kits are NOT CARB legal, and are legal in California only for racing vehicles which may never be used, or registered or licensed for use, upon a highway (off-road use only). The manufacture, sale, offer for sale, or installation of this product may also be illegal under the federal clean air act (42 U.S.C. § 7522(A)(3)).
